General Makit & Bakit Instructions

1.  Pre-heat oven to 375 degrees. Use standard kitchen oven. DO NOT USE IN MICROWAVE OVEN.
2.  Cover a cookie sheet with smooth aluminum foil.
3.  Place frame flat side down on covered cookie sheet.
4.  Use a teaspoon or straw, cut at an angle, to fill each section with specified color, heaping full
        in center and level at metal edges. Complete the filling process by using tweezers. Leave
        hanger hole empty. The plastic will shrink and flow into the corners as it melts.
5.  Place in the center of the oven. Bake approximately 15 – 25 minutes. Until crystals have melted
        to a smooth glass-like appearance. Note: White crystals remain opaque. Opaque colors may take
        a little longer to melt. They should be checked in the oven. If left to long, white may “yellow”.
6.  Remove cookie sheet and allow to cool, approximately 5 –10 minutes, then peel off foil.
7.  Attach thread to metal loop and hang over suction cup.

Helpful Hints

1.  Use in a well ventilated room. A slight odor is released during the baking process. This odor is
         not harmful.
2.  Plastic is flammable. Do not place near flame or broiler. It is as safe in an oven as a cake.
3.  During the cooling process you will hear crackling and popping sounds.
4.  We do not recommend using AIR BAKE cookie sheets. They add time to the baking process.
5.  ADULT SUPERVISION RECOMMENDED
6.  DO NOT TAKE INTERNALLY

Click here to view all Makit & Bakit Kits available!